Hi!
Great forum here. I am new to the forum. I figured you guys could help. I have some old OSA (old school audio) api clones and i want to replace the pots. Currently they have 10k, 1w, linear taper. The gain slope is weird with linear. Brent averill uses 25k log/audio. some people say to use 22k rev log.
I am not sure which to use, what impact they will have and where to get them. I would looooove some help from the wisdom here. Thanks!
note: These are old OSA's with actual 2520's. nice and crappy paint too! but they sound good... also they have pad, mic/line and polarity
Topic Tags
Comments
Contact Atlas Pro Audio, OSA US Distributer. They should be able
Contact Atlas Pro Audio, OSA US Distributer. They should be able to help. http://www.atlasproaudio.com
oldguitars wrote: Hi! Great forum here. I am new to the forum.
oldguitars wrote: Hi!
Great forum here. I am new to the forum. I figured you guys could help. I have some old OSA (old school audio) api clones and i want to replace the pots. Currently they have 10k, 1w, linear taper. The gain slope is weird with linear. Brent averill uses 25k log/audio. some people say to use 22k rev log.I am not sure which to use, what impact they will have and where to get them. I would looooove some help from the wisdom here. Thanks!!!!!!
The original API circuits had the variable gain trims connected as part of the lower end of the feedback resistor pair. The gain is thus 1 + (Rf/Rv) where Rf is the fixed feedback resistor and Rv is the sum of a small fixed resistor (to limit the gain) and the trim pot. From the equation, you can see that none of the standard linear, log or antilog law pots will give a constant number of decibels of gain per radian of rotation. However, the anitlog could well give the best result, but because it's wired as a rheostat and not as a potentiometer, a reverse-wired log pot is equivalent. If you use linear, you will get a steep gain increase near the top end of the travel.
I am puzzled by your saying that the pots in your circuit are 10K and that you have been told to use 22K. This does imply that these are not connected as in the original API circuit, but are conventional faders on the output. If this is the case, then log law is what you want. The value is not critical, so 10K to 25K should be acceptable depending on what is connected to the wiper.
I'd suggest you call to OSA and get the info from the source.
I'd suggest you call to OSA and get the info from the source.