Skip to main content

Hey there people..
I have a great pair of mini monitors that i want to use close to the monitor. however they are not shielded!
so have you any ideas how i could make the monitors shielded? so that i can use them close to my monitor.
I'm assuming that i have to surround the magnet some how..
cheers for any replies!

FAQ

Pro audio - how can I shield monitors?

You need a "magnetically conductive" material to redirect the field - like iron, steel, or some of the more exotic material.

However...

Depending on the steel you could just as easily magnetize it which would be a lot worse since it is a lot bigger surface area. If you want to do it correctly use mumetal.

Comments

Barefoot Sound Mon, 04/19/2004 - 11:14

Mu metal isn't necessary. Steel will work.

You can wrap a few layers of galvanized steel flashing around the top, bottom and sides of the cabinet. Just coil it around and don't make the corners too sharp. Bring it all the way to the front edge of the cabinet. If the flashing extends beyond the rear edge, that's good. This will give better shielding. You can put a thin layer of high density foam around the cabinet first, then construction glue between the metal layers to cut down vibrations.

If you're more adventurous, you could add "bucking" magnets to the back of the speaker drivers. However, this can somewhat alter the driver parameters, so you could potentially change the sound.

Thomas

Thomas W. Bethel Mon, 04/19/2004 - 17:19

Barefoot Sound wrote: Mu metal isn't necessary. Steel will work.

You can wrap a few layers of galvanized steel flashing around the top, bottom and sides of the cabinet. Just coil it around and don't make the corners too sharp. Bring it all the way to the front edge of the cabinet. If the flashing extends beyond the rear edge, that's good. This will give better shielding. You can put a thin layer of high density foam around the cabinet first, then construction glue between the metal layers to cut down vibrations.

If you're more adventurous, you could add "bucking" magnets to the back of the speaker drivers. However, this can somewhat alter the driver parameters, so you could potentially change the sound.

Thomas

Depending on the steel you could just as easily magnetize it which would be a lot worse since it is a lot bigger surface area. If you want to do it correctly use mumetal.

-TOM-

Been there done that.....!

Barefoot Sound Wed, 04/21/2004 - 07:22

Sanity,

No, copper won't work for a static field from a permanent magnet. You need a "magnetically conductive" material to redirect the field - like iron, steel, or some of the more exotic material.

However, electrical conductors do help with fluctuating magnetic fields. With fluctuating fields, there's always an accompanying perpendicular electric field component. It's just the nature of electromagnetism. The conductor will shield the electric field component and, therefore, the magnetic component can't propagate either. Power transformers (60Hz oscillation) will often have copper foil shields wrapped around them to reduce their emissions.

Thomas

anonymous Wed, 04/21/2004 - 07:57

You could save yourself time (and money from the sound of some of these solutions) buy getting a flatscreen. Bingo, problem solved.

Also, now you wont have the problem of interference with electric guitars. It took me forever to find out that the noise my Fender bass made was really interference from my CRT.

anonymous Wed, 04/21/2004 - 08:39

Thanks Barefoot, and noit ...

Yes my ATC monitors are not sheilded either, and you should see the size of the magnets in these puppies,,,

I plan on two LCD myself, but when budget permits,,,

although my monitors are 6 feet apart,,, not messing with my monitor,,

my hummble set up, shows the size of magnet on ATC SCM-20's

http://

Sanity Inn

x

User login