Search found 507 matches

The others I planned one mounting flush to the wall. Will that be fine ?

For the maximum efficiency, leave the 2'' gap behind. As a general rule, the gap should be equal to the thickness of the ab ...

Next time try to record a bit hotter, but not too hot. Somewhere around -6 dBFS for loudest peaks.

Hello Max, good to see you too my friend…

Well, this was just my suggestion. I don't know anything about Lun's place layout and possibilities, but in many cases like this, inside the apartments or ...

I would just repeat what I have mentioned a few times in this forum: place the computer, HDD etc. in the next room or hallway (behind the wall) drill the hole for all connection cables, then fill and ...

but it never occurred to me to use one of the channels for the card output (instead of the Rec In)

Mismatched terminology.

There isn't „Recording in“ on the mixer.

The mixer has:

TAPE IN – ...

- or pan the vocals hard right and everything else hard left. Then tweak and mix them afterwards in an audio editor.

This will end as two mono tracks. Nothing much left for mixing. I doubt you will ...

I'm thinkin we could get a clean recording if we recorded live off the floor (guitars,bass & drums) on one track and then record the vocals on a seperate track.

I'm afraid that's not possible w ...

I'm just curious, what is the model of Yamaha mixer?

I have the line out from the computer going into the RecIn on the mixer, but I thought I'd disabled it. I'll double check.

Now you are confusing me. Smile

„Recording in“on the mixer? Confused

I think t ...

Do you monitor the sound card (out) through the mixer when recording?

Between those I would pick up the Sebatron, even more if you look at 2000 model.

API lunchbox is also good idea, it's around 500$ and single channel pres are 700-750$ each. I have 2x512 and they ar ...

With the GR, LA and RME I would look further than B-Knob. SPL as a minimum, or better, ColemanAudio.

If you need just volume control, go passive ... Goldpoint Audio, DACT ...

Room treatment
Pair of good SDC mic
Pair of better micpre

The gap behind = thickness of the absorbent material (wool). That is for wall mounted broadband absorbers.

For the corner absorbers, the wider you close the corner the better.

for trapping the hot chicks maybe, not for bass waves Smile