1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

ADAT Spec confirmation

Discussion in 'Pro Audio Equipment' started by pcrecord, Feb 6, 2014.

  1. pcrecord

    pcrecord Don't you want the best recording like I do ? Well-Known Member

    Hi,

    I just need to confirm a thing
    1 ADAT input/output can deal with 44.1khz and it takes two to run 88.2 or 96khz right ?

    I ask that because the specs of the M-Audio Project mix says it can do 88.2 and 96 but It has only 1 input and 1 output.

    am I wrong ?
     
  2. TheJackAttack

    TheJackAttack Distinguished Member

    A single ADAT optical (not spdif) can run eight channels at 48k. It will run half as much when you double the sample rate. To make sure you are sync make sure you use both in and out optical cables.

    Sent from my SCH-I535 using Tapatalk
     
  3. Boswell

    Boswell Moderator Distinguished Member

    Just as Jack says. The ProjectMix has one lightpipe input and one lightpipe output. In ADAT mode, these can receive/send 8 audio channels at 44.1/48 KHz or 4 audio channels at 88.2/96KHz. To transmit 8 channels at the higher rates would need two lightpipe ports in each direction.
     
  4. pcrecord

    pcrecord Don't you want the best recording like I do ? Well-Known Member

    Oh yeah !! I didn't remember the part with 4channels instead of 8.
    Thanks guys ! :)
     

Share This Page