1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Advice Needed - How do i set my new gear up correctly???

Discussion in 'Recording' started by SPIT, Sep 27, 2004.

  1. SPIT

    SPIT Guest

    Heres a list of my current gear:

    PC

    Midi Keyboard

    MAudio MobilePre Audio Interface

    Mic

    Tapco s5 Active Monitors.

    Its setup like this :

    MIDI KEYBOARD--> PC--> MOBILEPRE--> TAPCO S5

    (MIC INTO MOBILE PRE)

    I have just brought this bunch:

    Access Virus C Desktop Synth
    Clavia Nord Lead Keyboard Synth

    Behringer Compressor

    Tascam 12 Channel Mixer

    How do i integrate my new stuff into my setup? Im completely LOST!

    Any help and I will be very grateful.

    Many THanks

    Kris
     
  2. Sanity Inn

    Sanity Inn Guest

    try this link,

    2nd and 3rd page have layout drawings for ideas depending on n eeds,

    hope it helps,,

    as stated in earlier post, i use this site as a guide for explinations and hookups,

    not to push the gear mentioned on site


    hope it helps you

    SI
     
  3. Sanity Inn

    Sanity Inn Guest

    lol

    bet it would help more with a link huh?!?!? lol


    oops


    http://www.tweakheadz.com/rigs.htm


    enjoy

    SI
     
  4. kevinwhitect

    kevinwhitect Active Member

    Or this:

    1) Midi Key ->PC <-> Mobilepre<->Board <->Compressor (Through board's channel inserts)

    2) Mic can go into mobilepre (w/ no comp) OR Board (preferably so that you can access the comp while tracking w/ the mic through the channel inserts).

    3) Connect one synth midi in to PC midi. On the unit that gets the direct signal from the PC midi out, connect its midi THRU to the second unit's midi in. That will pass the midi through the first to the second unit (I don't know how many midi outs your PC has...so this is the format for just ONE PC midi out--if you have 2 PC midi outs--connect both to the midi ins of the synth units). Audio outs on both synths go to the Board so that they can go into the mobilepre and be converted to digital for recording into the computer.

    Hope this points you in the right direction.

    Kev.
     

Share This Page