1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Anyone try the AT2020 on snare?

Discussion in 'Drums' started by drumist69, May 19, 2007.

  1. drumist69

    drumist69 Active Member

    Hi all! I was wondering if anyone's used the AT2020 to mic a snare...specifically, side-mic'ing the shell. The mic has pretty high SPL rating, but is there a chance of damaging it this way? Its only $90 or so, but its still a good mic, so I'd hate to ruin one! Thanks for any advice! Andy
     
  2. Randyman...

    Randyman... Well-Known Member

    You will likely clip the poop out of it. I doubt you would damage it, but expect clipped waveforms to result (you will be overlading the internal head amp). An external pad won't help, because the internal circuitry will get overoaded...

    Try it and see for sure.

    :cool:
     
  3. drumist69

    drumist69 Active Member

    I did give it a test run yesterday...seems to be fine. No clipping. I've got the kick mic and a pair of overheads, plus the 2020 on the snare shell. I get a good overall snare fullness from the OH's, and if I dial in a bit of the shell mic, I get a nice crack, with some shell resonance which is nice. I'll post a clip if I get time later on if anyone's interested. Andy
     
  4. jonyoung

    jonyoung Well-Known Member

    I've been using a 4 mic drum setup lately with 2020's as overheads from over the drummer's shoulders, I may never do individual drum micing again. I think I recall the SPL rating for the 2020 at 138dbSPL.
     
  5. Randyman...

    Randyman... Well-Known Member

    I'm honestly suprised the 2020 handled a tight-mic'd snare w/o clipping! Especially considering it doesn't even have a pre-attenuation pad on it. It seems like AT is doing cheap mics right :)

    Rock on.

    :cool:
     
  6. drumist69

    drumist69 Active Member

    I've been doing overdubs all night, and my brain is fried, but I'll try to post a few short clips of the drums asap. I ran MXL 603's as overheads (what can I say, all I've got, and really not so bad for the money...like almost none!). I tried MXL 2001's and the MSH-1's, but the 603's won this time. There was a Sennheiser MD421 on the kick, and the AT2020 side-shell mic'ing the snare. The weird thing was that the overheads were getting some occasional clipping at first, but not a bit of clipping on the AT2020. Seems like I remember them being rated at over 140 dB SPL handling or something. It adds a nice variable crack to the snare which can be dialed up or down depending on the song. Try to post something tomorrow! Andy
     
  7. drumist69

    drumist69 Active Member

    Okay, here's one of the songs we did this past weekend with the above mentioned mic'ing of the drums. Yep, AT2020 on the snare. Song is called "We Breath".... Sidekick

    There's still some work to be done on this one, and the vocals were only a scratch take, but I'm kinda lovin' the thickness of this song. We plan on adding a string quartet to this one...we'll see how that goes! Andy
     
  8. jonyoung

    jonyoung Well-Known Member

    Nice work, Andy.
     
  9. drumist69

    drumist69 Active Member

    Thanks, jonyoung! Andy
     

Share This Page