1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Anyone using DP4.x?

Discussion in 'Recording' started by McCheese, May 25, 2005.

  1. McCheese

    McCheese Well-Known Member

    I'm looking at switching to DP from PTLE, and was wondering if anyone had any experience with it, and how well it imports and exports PT sessions? Any other comments on it? I've got a shiny new G5 on the way, and I'm tired of the limitations of PT.

    Also, I don't see a lot of control surfaces aside from the Mackie. Can anyone point me to something along the lines of Digi's Control24 or ProControl setups? I've been thinking about biting the bullet and getting the new SSL DAW controller/mixer, but that's $80k.
     
  2. gdoubleyou

    gdoubleyou Well-Known Member

    I own DP4, but my main DAW is Logic7.

    DP supports OMF import/export. But you would need the DV Toolkit to get a version of Digitranslator that will convert PTLE sessions into OMF. There is no way to directly open a PTLE session.

    The Digidesign control surfaces only support PT.

    It's a beautiful app, deep and wide. Comes with a good set of effects plugs.

    I use it for printing out scores.

    8)
     
  3. fontane

    fontane Guest

    just switched to DP from Sonar... works quite well... as for PT, all I know is that it has additional support to run as a front end...

    you should be more than happy with DP over PTLE, wish i could give you more info... OH, fyi: DP does not support multiple outputs for audio units and is not VST compatible... for me, this was a hang up cause i could not use all the outs of kontakt 2... BUT, mach five and dp play well together in regards to multiple outs...
     
Similar Threads
  1. zdpinet
    Replies:
    0
    Views:
    772
  2. dwcook
    Replies:
    2
    Views:
    637
  3. anonymous
    Replies:
    6
    Views:
    1,302
  4. cdp
    Replies:
    10
    Views:
    1,130
  5. trock
    Replies:
    5
    Views:
    1,319
Loading...

Share This Page