1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Behringer BCF2000 and Cubase SX

Discussion in 'Cubase' started by GnzlO, Nov 28, 2008.

  1. GnzlO

    GnzlO Active Member

    Hello mates, today I bought a Behringer BCF2000 B-Control Fader to stop dealing with mouse and virtual knobs (I can't stand it), after instaling some driver I found it very hard just to set up the fades to the mixer of the cubase, I already set it on the Device set-up of the software, so cubase recognized it, but i'm very lost in ALL the million things I have to do just to mix through it,they (the fades) just dont do anything, the manual just describes everything but does not explain how to do this, does anybody have 15 minutes of their time to explain to me how to assign the fades to the Cubase mixer?...from that point I think I might be able to develop how to control more things through this hardware, I appreciate ANY help and thank you very, very much!

    Regards,
    gnzlo
     

Share This Page