1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Calrec PPM drivers

Discussion in 'Electronic Repair Modifications DIY' started by mberry593, Apr 13, 2012.

  1. mberry593

    mberry593 Active Member

    I bought 2 old Calrec PPM drivers on ebay some time ago. No documentation was included. I figured out the inputs/power/outputs & fired them up into a pair of Sifam PPMs.

    The good news: They came up exactly right with +4dBu = PPM 4 and the top end of the scale was right on.
    The bad news: The bottom half of the scale was far off with errors getting larger at the lower end. They both have identical errors.

    They have several adjustments & I guess I could hack around and figure out what they all do but it would be so much more civilized if I could locate an alignment procedure or at least a schematic.

    Can anyone here help?

    Thanks
     

Share This Page