1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

connection help

Discussion in 'Recording' started by dpianomn, Feb 1, 2006.

  1. dpianomn

    dpianomn Guest

    hello-
    here's the situation. i'm running a powerbook and have been using a motu 896 and 828 as my interface. i just got an A/D card for my ISA 428 and would like to use the A/D from the ISA and use the 896 purely as a firewire hookup.

    i hooked both units up using lightpipe, but have no idea what's going on. should i be using AES?

    forgive me,
    dave.
     
  2. dpianomn

    dpianomn Guest

    bippity-bump.
     
  3. Opus2000

    Opus2000 Well-Known Member

    Have you set the MOTU to clock from ADAT? You will need to do this to get a properly clocked system. Also set the inputs in the MOTU Control panel to ADAT as well and you should be good to go.

    Opus
     
  4. Mr-Nice

    Mr-Nice Guest

    Reading the owners manual on each device is a surefire way in finding out what is going on!

    :wink:
     

Share This Page