1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

conversion

Discussion in 'Converters / Interfaces' started by Jbrax, Dec 5, 2007.

  1. Jbrax

    Jbrax Guest

    I just got My new console today. I am very happy its beautiful..

    However I need to convert the inputs and outputs from Unbalanced
    to Balanced. Im realy looking for a DIY solution if possible..

    Any suggestion.. My board is useless until I do the conversion...
     
  2. bent

    bent No Bad Vibes! Well-Known Member

    You bought the 820, didn't you?
     
  3. Jbrax

    Jbrax Guest

    thats the 1...lol
     
  4. bent

    bent No Bad Vibes! Well-Known Member

    Can you take a pic of the back and post it?

    My old Tascam M520 had a lot of RCA's on the back, and the old balancing amp.
    I had a lot of jumpers on that bad boy.
    It also had the RCA inserts that you had to jumper to complete the connection when you weren't inserting anything.
     
  5. Jbrax

    Jbrax Guest

    yeah I get a pic up itll take a couple of days..lol
    I dont have a camera

    but all the Direct outs are RCA the Tape returns are Rca
    the bus sends are RCA both +4 and -10 16 of each of those
    line inputs are 1/4 in
    and Mic XLR oviously..

    Main outs are xlr and Rca

    Inserts are TRS go figure...lol

    fx sends are 1/4 left and right retuns are the same
     
  6. bent

    bent No Bad Vibes! Well-Known Member

    Well, sounds like you're in the same boat I was.
    The sends and buses are unbalanced.
    I just went and bought a bunch of RCA to 1/4" 8 pair snakes to deal with it (luckily, our A/D was a MOTU 24I/O - 1/4" ins and outs).

    I don't think there's a work around internally for those boards.
     
  7. Jbrax

    Jbrax Guest

    Idid find a solution to the inputs.this will rquire changing the rca's to TRS and a little circut to go with it, but still looking for a solution to the out puts..
     
  8. Jbrax

    Jbrax Guest

    ok upon futher reading of the Manual. Duh
    I dont have to worry about the inputs, the line inputs on the Ramsa are TRS Balanced. Now Il just have to convert the buses and the main outs to balanced
     

Share This Page