1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Creating power/distance effect in pop-rock vocals

Discussion in 'Vocals' started by studio-G, Nov 30, 2007.

  1. studio-G

    studio-G Guest

    Wanted to ask for advise on a specific vocal recording/mixing technique:
    I have noticed that in many pop-rock mixes the way that vocals done in choruses is different from the verses. The vocals sound thicker, powerful, but at the same time - more distant then the verse. An example would be "Who knew" by Pink.
    Does anybody know how this is done?
  2. thomNorth

    thomNorth Guest

    umm I dont if this is definite, but from experience, first record a few vocal 'double' tracks, try to get your vocalist to imitate the original as close as possible to avoid syllabic confusions, then lower their volumes considerably till they dont compete with the original, that will take care of thickness factor, then just add reverb as an insert to all your tracks to provide the space. hope that helps.
  3. studio-G

    studio-G Guest

    I will try this
  4. cfaalm

    cfaalm Active Member

    Feb 21, 2005
    Home Page:
    From my psycho acoustics notes:

    Distance is determined by 4 factors
    Perceived loudness
    Direct vs reflected sound ratio
    High frequency absorbtion
    Delay, not only as an effect but on the sound itself

    So you can:

    raise the aux send to the reverb.
    another type of reverb, different settings, add another to the one you got.
    another setting (volume, EQ, FX, Panning, doubling) of the vocal parts.
    track with a different mic, preamp, ambient mic technique.

    Try increasing the pre-delay and HF damping on the reverb you are using.
    Try a different balance in the vocal parts.
    Though I am not familiar with Pink's song it could well be that the exta parts did not have much reverb on them in the verse, but they get that in the chorus.

    Reverb as an insert on the individual track is a way, but when working ITB it is a waste of resources (CPU cycles). When more than one track need the same effect, use an aux track. Send signal from the tracks post fader to an aux track.

    Rock on!!
  5. TheFraz

    TheFraz Active Member

    Feb 5, 2007
    its pretty common to preform production techniques to make the chorus stand out in contrast to the verse.

    There are countless things you can do. And every one has their preferred methods. I for one like to use some digital delay to create a chorusing effect. also bumping up the presence in the EQ helps allot to make it really stand out. I tend to make the pre delay on the verb longer as well. not much, but it gives you the "in yo face" type feel to a powerful vocal delivery. even if its very subtle.

    there are plenty of things you can do. try out some ideas for your self.
  6. studio-G

    studio-G Guest

    I'll keep on trying

Share This Page