1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Cubase SX3 Question

Discussion in 'Cubase' started by JesterMasque, Jun 28, 2007.

  1. JesterMasque

    JesterMasque Active Member

    In Cubase SX3 part of the mixer is for the input channels. I recently figured out last night that the eq's and inserts on those channels ARE in fact destructive! But the problem is that it seems you can not hear what it sounds like until you record and playback. Is there a way to moniter the input channels with the inserts etc. applied to them? Thanks!
     
  2. pr0gr4m

    pr0gr4m Well-Known Member

    First...Duh.

    Second...it's only descructive if you use them in that way. They should be use in a constructive manner... ;P

    OK, kidding aside, I don't understand the question...Do you mean you can't hear the Eq and insert efx that are being applied on the input channel until after you have recorded the track and are playing it back? You don't hear the affect while recording?
     
  3. JesterMasque

    JesterMasque Active Member

    No I don't hear the effects in my monitor mix. I do have an E-MU 1820M which uses the E-MU Patchmix program if you are familiar with that. Is there any other information I could give that might aid you in helping me?
     
  4. dementedchord

    dementedchord Well-Known Member

    you probably are set up as direct monitoring in cubase... doesn't patch mix support it???
     
  5. JesterMasque

    JesterMasque Active Member

    Is that what the Direct ASIO Monitoring session is on Patchmix? I will go try that now...
     

Share This Page