1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

D.W. Fearn VT-7

Discussion in 'Dual Compressors' started by audiokid, Oct 25, 2011.

  1. audiokid

    audiokid Staff

    ATTACH1325.vBATTACH

    The BD.W. Fearn VT-7B has an all Class-A Vacuum Tube Stereo Compressor. The gain reduction elements utilize circuitry that duplicates the sound and characteristics of the finest classic vacuum tube compressors, without depending on tubes that are no longer manufactured. The control circuitry is modern solid-state analog.

    The two channels may be used independently or linked together for stereo. A built in sidechain high-pass filter may be selected to reduce the compression on bass-heavy material.

    BControlsB (each channel)

    TABLE
    TR
    TD="width: 100%"
    LIST
    *Threshold
    *Gain
    *Attack
    *Release
    *HarderSofter
    *SeparateLinkLink HPF
    LIST
    The VU meters may be switched between indicating gain reduction or output level.

    The D.W. Fearn VT-7 has a highly-transparent sound, although it can be used more aggressively when needed. Artifacts of the compression process are substantially lower than in most other compressors.

    The two channels may be used independently, or linked for stereo. In addition, a third position on the Link switch inserts a high-pass filter (HPF) in the sidechain to reduce the gain-reduction sensitivity of the VT-7 to low frequencies. This is a gentle roll-off, nominally at 100Hz. This allows a bass-heavy mix to have a better frequency balance, and prevents heavy low frequency audio from modulating the audio level. (NOTE: The photo of the VT-7 shows an older unit without the Link HPF position.)

    Like all our products, the VT-7 is designed to process high-quality audio and make it sound even better.

    The VT-7 is equally adept in tracking as well as as a bus compressor. Even jazz and classical tracks can be sent through the VT-7 for some mild gain control without obvious effect other than a significant improvement in the overall sound of the mix.

    BPerformanceB (no gain reduction, unity gain)

    Frequency Response: 20Hz - 20kHz +- 0.5dB, -3dB at 5Hz and 65kHz

    THD: less than 0.07%

    Signal to Noise Radio: better than 80dB
    TD
    TR
    TABLE
     

    Attached Files:

Share This Page