1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Digi 001 and Digital Performer 3 problem

Discussion in 'Digital Performer' started by ayinde, Nov 11, 2001.

  1. ayinde

    ayinde Guest

    I have a mac g4 digi001 and DP3 I use micro xpress
    as an interface. Dp3 does not see the 001 hardware
    I've talked to everyone and tried much I'm sure it is something small I'm doing. someone please give me some insight. also will I have these problems when ever I get Nuendo?
     
  2. Opus2000

    Opus2000 Well-Known Member

    Well...in DP 2.7 you go under Basics to MOTU AUdio System and set it to use TDM...that should set it up to use with the 001..plus you need the latest version of direct connect. I forget where you need to put the direct connect to have it recognized in DP. In fact I'm doing this tomorrow for a G4 at the place where I tech a lot so once I do it I'll post the info.
    Just an FYI...the Mac version of Nuendo hasnt been running well at all...
    Opus
     

Share This Page