1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Ensoniq control surface and protools

Discussion in 'Consoles / Control Surfaces' started by Trenchcoatangel, Apr 28, 2003.

  1. OK, here's the deal. I have an oppertunity to pick up an ensoniq c16 control surface for a good deal, the question is, I have an digi 001 at home, I was just wondering if any of you knew if this surface was compatible with protools?

    I did a search out on the net and found nothing. I was just wondering if any of you knew. If ya do, kewl, if you don't, can't blame ya, doesn't look like a question much asked.

    Thank you much
    Rob
     
  2. Blutone

    Blutone Guest

    I think Digi and ProTools are locked down. Kinda like a proprietary thing. So, I think, the answer to your question is nope. BTW, don't quote me on this. There are folks here that know a lot more than I do about it. Stay tuned. They'll chime in. :D
     

Share This Page