1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

hdd config...can i have it both ways?

Discussion in 'Recording' started by bencrud, Feb 21, 2004.

  1. bencrud

    bencrud Guest

    i just got my asus p4c800 deluxe and am considering drive configurations. should i have my os on a raptor with SATA and then my audio drive and video drives ATA? wouldn't having a 10,000 rpm hdd for my os speed up my applications or can i even use a SATA drive in conjuction with ATA drives. thanks for the help!
     
  2. jscott

    jscott Guest

    Your applications will not be the issue. The fastest drive should always be true audio and sample related data. Midi data is a non-issue.

    How do you intend to configure the 3 drives, because it will make a difference.

    Your main apps drive PATA should be the boot drive, Primary Master. The main Audio data drive should probably be the Secondary Master. If video is to be the heavy use, I'd think I'd make it the SATA device 1. You can only have 2 SATA drives on that board as I recall and that would be the 3rd channel, SATA??

    I can check this tomorrow, but not where I'm at now.
     
  3. bencrud

    bencrud Guest

    i see what your saying but a SATA drive for video is out of the question. the drives are too small and expensive for the amount of data that i will be putting on them.
    this is the config i thought would be best?

    SATA WD Raptor (boot drive, os and apps)
    PATA Primary Master Audio Drive
    PATA Primary Slave DVD RW
    PATA Secondary Master Video Drive
    PATA Secondary slave ?
     
  4. mjones4th

    mjones4th Active Member

    The best config is a jroberts said, but that doesn't solve your space dilemma. I'd suggest using the raptor for playback of video, and using audio drive for storage of older video. Keep the raptor clean and unfragmented, and transfer stuff to it as you need.

    Having a faster boot/apps disk will make a small difference, but basically only when starting the OS or starting the app, because it will load to RAM a little faster. But the OS and the apps will only run faster if they make a lot of calls to their code on the hard drive. But nowadays, an OS or app uses RAM to hold the code it needs to execute 80% of its functions.
     

Share This Page