1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Headphone mix in Pro Tools Le

Discussion in 'Pro Tools' started by Phresh-Music, Dec 4, 2007.

  1. Phresh-Music

    Phresh-Music Guest

    Hi all,

    Does anybody know how to do a headphone mix in Pro Tools Le? Any advice or suggestions would really be appreciated. Thanks in advance. :D
  2. Hi Phresh-Music.

    Firstly, what are you wanting to send to the headphone mix?

    Lets say it's a guitar audio track then you could try this:

    1. Create a mono or stereo Aux track for your headphones.
    2. In the "Sends" section of your "Guitar" track, set a Bus up (Any availiable).
    3. Set the input of your Headphone Aux track to the same Bus as the one you used on the "Guitar" track.

    You should now be able to hear the "Guitar" track through the Headphone track.

    You can use the fader on the "Guitar" track to determine how much signal you want going to the headphones but this will also limit the signal coming from the "Guitar".

    Alternatively, by holding "Command" on Mac or "Control" on PC, and selecting the insert Bus on the Aux track, you can change the view so that a smaller fader appears within the send box.

    By doing this you can select "P" which will allow you to control the amount of signal from the small fader independent of the master fader.

    Hope this helps
  3. Phresh-Music

    Phresh-Music Guest

    Thanks tobacco_slammers,

    I'll try that as soon as I have the time. Finding time is the most difficult thing for me now as I have so much work to catch up in school. I'll let you know it went. Later! 8)

Share This Page