1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Help needed - OS X, SX 3 and 3 RME Fireface's

Discussion in 'Converters / Interfaces' started by stahfishpro, Apr 5, 2006.

  1. stahfishpro

    stahfishpro Guest

    Gday all, i have a question about getting 3 firefaces to appear in SX as 3 seperate devices for I/O to my console.
    At present i use both the ADAT ports to route things to and from the 1st unit to each other unit, becasue SX only see's the I/O of the 1st unit.

    Has anyone got or seen a setup similar to this that might know more.

    I hope this makes sense, it is a bit crazy. I can explain more if needed...

    cheers
    Steve.
     
  2. mud5150

    mud5150 Guest

    does the rme software recognize the other units
     
  3. stahfishpro

    stahfishpro Guest

    yeh, the rme software see's everything ok, and everything works to the console etc...
    i would like to see in the SX I/O setup that i can select unit 1 outputs 1-28, unit 2 outs 1-28, unit 3 outs 1-28...this way i free up the adats and it makes the routing in totalmix(s) less of a nightmare....
     
  4. gdoubleyou

    gdoubleyou Well-Known Member

    If you are on OS 10.4 or later you can combine control over multiple devices under Aggregate Devices, then all three devices will appear as ONE device to SX.

    Audio/Midi setup utility found in the utilities folder.

    8)
     

Share This Page