1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Hill Multimix power connector

Discussion in 'Recording' started by Wasko, Aug 30, 2006.

  1. Wasko

    Wasko Guest

    I have one of those older analog Hill Multimix mixers, 16x4, with the external power supply (PS1)... But I don't have the power cord..
    I do have connectors that I can use and this is where the stupid part comes in.

    On the back of the power supply it shows which pin is what. ie: the voltages for each pin, 1 through 5.

    Now on the back of the mixer, it shows nothing and I don't know which voltage goes to what pin.

    Is it safe to 'assume' (prolly not) that the pinout numbers on the back of the power supply are directly equal to the pin numbers on the Din connector for the mixer?

    Thanks in advance,

    Jim Waskowich

Share This Page