1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

insert cable woes..

Discussion in 'Accessories / Connections' started by rockstardave, Jun 6, 2007.

  1. rockstardave

    rockstardave Active Member

    ok so i just ordered a 12ch insert snake (12 trs -> 24 ts) off ebay and it showed up. great start right?

    well it's labeled poorly!

    i can get corresponding channels because all ends are color coded.

    BUT there's no differentiation between the TS ends. so how to i fix this?

    will trial and error work? what happens if i plug the ends in the wrong spots? like if i want to use a compressor as an insert .. but i plug the SEND ts side into the output of the compressor and the RECEIVE into the input?

    ya know?

    is there any harm that this could cause or will it just .. 'not work'.

    if it doesnt work, i can switch of course (trial and error). but i dont wanna mess up any of my gear.

    thanks!
     
  2. Link555

    Link555 Well-Known Member

    do you have a multimeter? Just use a ohm meter to check the connections.
     
  3. rockstardave

    rockstardave Active Member

    i do not have a multimeter and do not really want to buy one because i'm broke right now.

    however i DO want to use this gear tomorrow. thoughts?
     
  4. Cucco

    Cucco Distinguished Member

    There's no harm in "plug and play" testing.

    The tip should be the send, so, take the output (preferably an insert) from your mixer and feed a signal out of it. Feed it into something with a meter (a compressor, an AD, whatever...)

    If you get signal at the destination device, you have the tip cable. If you have no signal, you have the ring.

    Of course, the other option - if these are Neutrik or similar connectors and you can take them apart, simply look at the cables' guts and see how they're wired. I'm guessing if it was a cheap ebay cable though, they're probably molded connectors.

    Good luck!

    J.
     
  5. BobRogers

    BobRogers Well-Known Member

    First, I'd get a magnifying glass and look really close to make sure there is no marking on the TS end or the wire. (I'll bet it's marked in some strange way and you are going to kick yourself when you figure it out.)

    Anyway, either rig up something with a 9V battery and a little bulb from a flashlight or use something like a reverb unit that will only work one way when inserted and go through the channels using the unit as a test device.

    Good Luck
     
  6. Link555

    Link555 Well-Known Member

    I know you have no money, but in the future plan on buying a meter. You get one for $10 bucks. It will save you alot of time. If you like I can tell you how to use it, just send me an email when your ready. Best of Luck!
     
Similar Threads
  1. Gnosh
    Replies:
    4
    Views:
    1,255
  2. johntpt25
    Replies:
    1
    Views:
    1,022
  3. Cucco
    Replies:
    4
    Views:
    1,863
  4. audiokid
    Replies:
    0
    Views:
    492
  5. Schirall
    Replies:
    5
    Views:
    866
Loading...

Share This Page