1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Instrument "too high" in Reason.

Discussion in 'Reason' started by Ben_Rangel, Apr 23, 2008.

  1. Ben_Rangel

    Ben_Rangel Guest

    I am trying to make a synth melody, but each time I press a key the tone comes in too loud, although the sustained tone afterwards sounds okay. How do I decrease the initial "attack" sound so that I get a smooth tone even from the beginning?
     
  2. Codemonkey

    Codemonkey Well-Known Member

    I come up with weird solutions, but I would try a noise gate. Have a fast time for it to activate, and a slow time to release. When its silent, the gate blocks the noise, then when you press the note, you have a fade from the start of the note, long enough to cancel out the attack. When the note ends, the gate activates quickly - so that it's ready for the next note.

    There will be other ways to do this though, I'm not familiar with Reason or synths.
     
  3. Ben_Rangel

    Ben_Rangel Guest

    Thanks for your reply.
    Sounds too complicated though. There must be an easier way to do this? Anyone with Reason experience?
     
  4. hueseph

    hueseph Well-Known Member

    There should be a way to adjust the velocity. Check your manual.
     
  5. Ben_Rangel

    Ben_Rangel Guest

    Adjust the velocity you say?
    Well, that did it. Thanks.
     
  6. hueseph

    hueseph Well-Known Member

    Glad you worked it out.
     

Share This Page