1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Logic TDM output issue.

Discussion in 'Logic' started by marksaund, Feb 21, 2010.

  1. marksaund

    marksaund Active Member

    I'm trying to use Logic with Digidesign TDM hardware system and I can't seem to output an audio track to a single output channel. I only get an option of 'output 1&2' or 'output 3&4'. I can't just select a mono audio track to output to 'output 1'. I normally use an Apogee Symphony system in core audio mode and this isn't an issue. Is this a limitation of a TDM setup? I'm in Metropolis Studios in London with the clock ticking so if anyone can help asap that would be greatly appreciated. Thanks Mark Saunders
     

Share This Page