1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Looking For Matched Condenser Mics

Discussion in 'Microphones' started by springforever56, Jun 10, 2015.

  1. springforever56

    springforever56 Active Member

    OK, here's the scoop. I bought a Tascam DR-40 a couple of weeks ago and I love it. The built-in in mics are great. So now I want to get a set of match condenser mics that are as good or better than the DR-40 mics. I looked for the frequency chart for them but can't find anything.
    So does any one know the specs on these mics, what is equal to them or have a suggestion for a set of matched condenser mics?
    I want to use them mainly for "field" recording, say for nature or an outdoor concert, fireworks show, awesome sounding vintage cars, WW2 airplanes (I found a vintage car meet and WW2 airplane museum for this), etc. I also know a lot of musicians so I want to be able to use these mics just about any where.
    I looked at the Audio-Technica 2022 because of the X/Y pattern but you can't separate them and place each mic at a different spot. I also looked at Rode M5. My budget is $250.
     
  2. moonbaby

    moonbaby Mmmmmm Well-Known Member

    I have a DR-40 that I use for spot work, it is a good machine for the $$. If you like the internal mics, that's where I would leave it. You are really at the mercy of the internal mic preamps, which are not particularly quiet, if you go the external mic route. I tried to use the Tascam with a pair of SDC's (Shure SM81's), but the phantom power ate up the battery life so quickly that I gave up on that idea. Added to that is the fact that many times a stereo mic is a better course than a pair of external mics, especially if you are trying to capture environmental and ambient sounds.
    As far as frequency plots and charts on mics, these can be very misleading, and they tell you nothing about how the mics will work in the field.
    Just be sure to get a 'dead cat' (wind screen muff) for the rig you have now and learn to use it. Realistic upgrading will require a bigger budget than you
    listed before you realize a discernible improvement in the results.
     
  3. Kurt Foster

    Kurt Foster Distinguished Member

    doubtful the mics in the Tascam are of any significance. i mean they are just fine but not something to write home about ..... almost any sd condenser will be as good or better, even cheapies. look to see if anyone has a pair of MXL or the like used on CL or FleaBay. best of luck.
     
  4. springforever56

    springforever56 Active Member

    Thanks for the info and advice. I made a dead cat out of fake fur for the Tascam and it works good in low wind but i'm not sure about higher winds.
     
  5. moonbaby

    moonbaby Mmmmmm Well-Known Member

    Tascam makes an accessory kit that includes a muff that seems to work pretty well. It's less than $30 and did fine on the beach recording early morning surf recently. Rycote also makes a nice one that you can get for less than $40, and that one is probably even better, as Rycote is the king of muffs (that didn't sound PC, did it?).
     
  6. springforever56

    springforever56 Active Member

    Thanks moonbaby.
    I wasn't sure which wind muff to get, I'll look at those ones. The hard thing about making your own for a hand held recorder like the DR-4o is there isn't much room, as soon as you cover the mics it seems like your covering the earphone jack.
     
  7. springforever56

    springforever56 Active Member

    The thing I realize about my home made wind screen for the Tascam is that where the seems of the screen are are right over the mics. There is hardly any of the fur in that area, it's mainly the cloth backing, so I may have to redo it until I get a real one.
     

Share This Page