1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

M-Audio Fast Track Ultra always resets to 44.1khz when recording in Logic 9?

Discussion in 'Logic' started by antiuser, Jan 4, 2012.

  1. antiuser

    antiuser Active Member

    Jan 1, 2009
    I'm using my M-Audio Fast Track Ultra with Logic Pro 9, and it seems to be limited to a 44.1khz sample rate for some reason? If I go in the Audio MIDI setup utility on my macbook pro, I can set the sample rate for the Fast Track there to the maximum (96khz). I can also do the same in the Fast Track's control panel software. Except that every time I launch Logic and create a channel with the Fast Track as input, the sample rate in the control panel is shown as 44.1khz and when I change it, there is gigantic latency. How do I make Logic use the full sample rate of the interface? I've been looking around everywhere but so far I haven't found any place where I can change that and have it stick? Thanks in advance!

Share This Page