1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

m-audio octane channels not appearing in cubase

Discussion in 'Cubase' started by eoink, Dec 1, 2005.

  1. eoink

    eoink Active Member

    Hi,
    I am using a m-audio octane connected to a firewire 1814 via toslink to record various tracks into cubase sx2. Recently, when setting up the channels in the vst connections, I noticed that cubase no longer recognises all of the optical channels but only recognises the first two. Has anyone come across this problem before?
    Thanks in advance
    Eoin
     
  2. mud5150

    mud5150 Guest

    prob in spdif mode don't know how but you need to switch it back to adat to get all 8 ch
     
  3. jonnyc

    jonnyc Member

    Besides what mud said as a possibility also make sure you're at 44.1 or 48. I believe on the adat units that aren't 96 and up, only the first two channels will be recognized when you're attempting to record at 96khz. I had an ada8000 and when I'd set up a 24/96 recording only the first two channels were recognized.
     

Share This Page