1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Mackie 8 bus to PC

Discussion in 'Recording' started by wmcnulty66, Apr 9, 2007.

  1. wmcnulty66

    wmcnulty66 Guest

    My friend has a Mackie 32:8 that he wants to use to use for his recording studio. I'm not a recording engineer; I’m a PC tech. He asked me to find a way to record on his pc from his Mackie board.

    Do I need to get him a special sound card or interface card? Is there a USB interface he can use? What software would you recommend?

    He would like to keep the cost reasonable but any suggestions will be appreciated.
     
  2. Link555

    Link555 Well-Known Member

    How many tracks does he need to record at one time? U will a need a sound card and software.
    M-audio makes a lot of cheaper cards, some USB some PCI.
    MOTU is another good cheaper card.

    Software wise Cubase is pretty inexpensive, also there are few free daws out there like
    http://www.kreatives.org/kristal/index.php?section=details

    But it greatly depends on how many track he wants to record at one time.
     
  3. HansAm

    HansAm Active Member

    The most used method on this mixer is to tap the signal from the 8 buses. If he only needs 8 channels at the time you can buy a regular 8channel AD/DA converter. Could be anything realy, motu, m-audio, presonus are just some brands.
    If he only needs 8 channels, then you can set up a permanent taping from the 8 buses and he can just rout the channels to the buses as he goes along. If he needs more he need to tap the signal from each channels insert point or line out..

    Just random thoughts now as Im working the night shift. but i hope you can use some of it.
     

Share This Page