1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Mackie 800r to Digi 002 rack connection help

Discussion in 'Recording' started by Dossetter, Feb 27, 2007.

  1. Dossetter

    Dossetter Guest

    I recently purchased a Mackie 800r to upgrade the pre's on my existing digi 002 rack. I connected them using a d-sub snake, which goes out from the mackie and into the digi 002 through 8 1/4" cables.

    What else do I need to do (software calibration, etc.) to get this setup to work?
     
  2. Dossetter

    Dossetter Guest

    I'm pretty sure it has something to do with the I/O, though I'm not entirely sure exactly what I/O is. Oh, by the way I'm running protools LE.
     
  3. Boswell

    Boswell Moderator Distinguished Member

    Are you saying you actually have a problem getting this to work with the analog interconnect? Is there a reason you can't use an ADAT lightpipe connection between the two units?
     

Share This Page