1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

MIDI Recording w/ Cubase SX3

Discussion in 'Cubase' started by JesterMasque, Nov 8, 2007.

  1. JesterMasque

    JesterMasque Active Member

    I have an M-Audio 88ES that I run into Cubase SX3 using Eiderol's Orchestral VSTi.

    I am attempting to assign my modulation wheel to "volume." I went through all of the steps correctly, and when I roll the wheel I see the MIDI signal flashing in Cubase, however it does not do anything. Would this be a problem with my 88 already? (I just bought it.) I do not think it would have to do with the VSTi because this is a function that Cubase manages, correct?

    FYI: The portamento and pan functions work, just not the volume.

    Thanks a lot in advance!
     
  2. pr0gr4m

    pr0gr4m Well-Known Member

    If you see the MIDI signal in Cubase, it wouldn't be a problem in the 88.

    Do you see the controller data in the MIDI track?

    Do you have the MIDI data in Cubase mapped to sent as controller number 7 to your VSTi?
     
  3. JesterMasque

    JesterMasque Active Member

    All fixed! I forgot about the volume trim that is already on the 88. Thanks anyway pr0gram!
     

Share This Page