1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

minimoog and fruityloops

Discussion in 'Recording' started by macombaland, May 17, 2006.

  1. macombaland

    macombaland Guest

    I have some compositions just about completed in fruityloops. My problem is that some of the instances of minimoog wont allow me to turn up the volume. I have minimoog running as a DXi plugin and when i open it from fruityloops the volume is way to low. I can turn it up and save it in on the minimoog but it goes back down as soon as i press play in fruityloops.

    If i run minimoog on its own the volumes are all in the correct spot. basically the volume presets arent working correctly in fruityloops. any help would be appreciated.
     
  2. saemskin

    saemskin Active Member

    whenever and wherever possible, use the vsti instance of your softsynth, not the dxi.
    Unless you are using a dxi only host such as soundforge (well, not anymore!) you shouldnt even bother installing the dxi version.
     
  3. pr0gr4m

    pr0gr4m Well-Known Member

    Agreed. The last version of Fruity I used had a VST wrapper thingamabob.

    If that doesn't make a difference, when you recorded, was the volume of the minimoog higher? Could something be sending midi volume control messages to the minimoog?
     
  4. macombaland

    macombaland Guest

    i think the volume of the moog was lower when i recorded the midi track. that could be the problem. ill check it out when i get home..
     
  5. saemskin

    saemskin Active Member

    I believe program is implying you may have unknowingly recorded some automation.
    To check press F8 and go to current project>automation and see if there is anything listed there. All your automation is logged there.

    Though I'm not completely sure FLS supports DXi automation? hmmmm......
     

Share This Page