1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Multiple Headphones Help

Discussion in 'Monitoring / Headphones' started by Atmosphere, Apr 14, 2008.

  1. Atmosphere

    Atmosphere Guest

    Hi there. I'm looking for a way to hook up multiple headphones so more than one person can hear the mix while we are recording.

    This is my current setup:

    - E-mu 0404 USB 2.0 Interface
    (Dead Link Removed)

    - Behringer Xenyx 1222FX Mixer
    (Dead Link Removed)

    - Behringer AMP800 Headphone Amp
    (Dead Link Removed)

    How can I work all these together? I'm basically only using the Xenyx for my microphone that I can use as a talkback mic.

    I am using Behringer Truth monitors through the E-MU and I tried using the Main 1/8 out of the E-MU to my headphone amp but then I realized that it wouldn't work because my monitors are in a closer range to where I record so the mic would pick up the monitors since they Main output is the same with the 1/8 and the 1/4 outs.

    How can I hook up a headphone amp to work properly?

    Thanks alot![/url]
     
  2. bent

    bent No Bad Vibes! Well-Known Member

    Aux out on the Behr***ger mixer into the headphone amp.
     
  3. Atmosphere

    Atmosphere Guest

    The only thing going into the Mixer though is just a microphone. The E-MU isn't going through the mixer at all... unless I'm misunderstanding you.
     
  4. mwacoustic

    mwacoustic Guest

    Ok, so you have only one mic, and it is going into the mixer. What do you have the outputs of the mixer going to?
    And what is going into the inputs of the EMU?

    Are you set up so you can listen to one set of headphones plugged into the headphone jack on the EMU ok? If so, then all you need to do is get a y-cable (1/4 stereo to two 1/4 L/R) to go from the EMU headphone jack into the inputs on the headphone amp.

    I'm guessing that you have some other issue, because that seems to simple...
     
  5. bent

    bent No Bad Vibes! Well-Known Member

    Run the EMU's stereo outs through the mixer, connect the mixer's main outs to your speakers, mixer aux one out to the input of the EMU, mixer aux two out to the HP amp.
     
  6. Atmosphere

    Atmosphere Guest

    I will try that, thanks for the help everyone!
     

Share This Page