1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

need help

Discussion in 'Recording' started by dhardy, Oct 8, 2009.

  1. dhardy

    dhardy Guest

    I have a mx2442a mixer that i am having trouble recording from. I dont know if i have my recorder hooked up right, i have a manual thought i had it hooked like it said but no sound.
     
  2. Boswell

    Boswell Moderator Distinguished Member

    For multitrack recording from the MX2442A mono channels you need to use the channel insert jacks as direct outs. The diagram in section 7.1 of the MX2442A manual shows how to wire TRS jack plugs to achieve this. You get an unbalanced, line-level signal out.

    If you do not want to wire your own plugs, you could use conventional TS looms with Hosa DOC106 adaptors. The type of plug needed on the other end of the loom will depend on what type of input sockets there are on your recorder or interface.
     
  3. dhardy

    dhardy Guest

    Can you run an additional mixer out of the mixer i have,and if so where would i come out of.
     
  4. Boswell

    Boswell Moderator Distinguished Member

    If you're asking what I think you are asking, you would use the same method of using the inserts to extract the signals. If you want to run the second mixer as well as do recording, you would need to split the sends from the insert jacks to go to both the interface and the second mixer.
     

Share This Page