1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

P4 2.4B & Hyperthreading?

Discussion in 'Recording' started by garysjo, Dec 2, 2002.

  1. garysjo

    garysjo Active Member

    I seem to recall a thread a while back where somebody heard rumors that the P4 2.4B Northwood (533FSB) might support hyperthreading. For some reason I can't find the thread. Anybody know if this rumor is true???? Thanks!
     
  2. Opus2000

    Opus2000 Well-Known Member

    Well, you need a BIOS hack to do this and it's not easy...so in the long run. No. Believe me...I was hoping that it would be easy. I'll go check out the VR Forums to see what the status is of the attempts. Haven't been there in a bit since I found out from my good source that it can't happen unless you know BIOS engineering and software writing.
    Opus
     
  3. garysjo

    garysjo Active Member

    Well sounds like it's not for me. I'm going to order the chip today anyway with the P4PE mobo. Can upgrade the chip at a later date when those ridiculous prices come down!

    I'm finally joining the club! My AMD machine is being retired to home use!!!

    P4B 533MHZ
    P4PE/R/L/SATA
    512MB Crucial 2700
    Matrox G550
    Seagate Baracudda IV 40G - OS
    120G WD 8mb Cache - audio
    Enermax 350 whisper P/S
    Zalman "flower" heat sink/fan
    Vantec Iceberg CCB-A1A chipset cooling kit
     
  4. bgober

    bgober Guest

    i just built a box for a friend very similar to your specs. your gonna love it. i don't know if you are going to need the extra cooling though. this is one of those wwod (what would opus do) moments. good luck.
     
  5. garysjo

    garysjo Active Member

    Do you mean the chipset cooler? If I don't need it great, less noise. I'm going with the Zalman because it is reportedly quiet and very effective. Whadda ya think Opus? Fan for the Northbridge or not?
     
  6. Opus2000

    Opus2000 Well-Known Member

    No, no chipset cooler is needed. If you want a cooling system for it go for the water cooled systems as that is completely noiseless. To be honest the stock fan is fine for the Intel CPU's. If you plan on doing some serious overclocking than you would want serious cooling. Stick with the default values and you're all set to go. I've done extensive Sandra burn in tests with the stock fan and an enermax PSU and the board did not get that hot at all!
    Cheers
    Opus
     
  7. garysjo

    garysjo Active Member

    Cool! :) I'll put the fan on my AMD machine which has a shitty fan at the moment. it's overclocked and needs to stay cooool!
     
  8. Opus2000

    Opus2000 Well-Known Member

    Yes. AMD MUST have a good cooling system as those CPU's do run extremely hot!
    As Always...Cheers!
    Opus :c:
     
  9. jmoro

    jmoro Guest

    Hyperthreading is a myth. In digital audio work it will actually slow down your processor's speed. Don't hack your bios or waste ur time for a 10% constant neg/pos swing
     
  10. garysjo

    garysjo Active Member

    Whether it's a myth or not I do not know, (or care at this point) I've been using this new machine for a few weeks now and it screams. The performance exceeds my current needs! Have not loaded it down heavily with VSTI's yet, but I know it will do a lot better than my old 1.1G Athlon.
     
  11. Opus2000

    Opus2000 Well-Known Member

    jmoro
    Hyper threading is not a myth. Only the xeon processors with HT will slow you down. The P4's(Northwoods) are happily cruising along. The problem,"if" there was a problem, would be that there is no software to truly take advantage of it yet. In all actuality most DAW software IS multi-processor friendly so you won't lose any performance. If you read the specs on hyper threading and read some pretty informative articles(such as the latest issue of CPU) you would find that it's actually a good thing.
    I do agree about hacking the BIOS as that's not easy in any way..nor would I recommend it.
    If you're going to post why something is bad...provide us with information please. M'kay
    Opus :roll:
     

Share This Page