1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Pads for Syteks

Discussion in 'Pro Audio Equipment' started by joek1972, Feb 20, 2005.

  1. joek1972

    joek1972 Guest

    Hello all. Just purchased the Sytek MPX-4Aii mic pres, and will apparently need to pad down the signal in order to run the pres "hot" to my DAW. Any ideas about the most cost-effective way to achieve this?

    I have a Mackie 1202-- will this work? I suppose I could run two channels through the main outs and two channels through the Auxes. Just wondering if there's a better way.

  2. AB2

    AB2 Guest

    ATTY 2 by A designs is the way to go!

Share This Page