Patchbay Wiring Configuration

Discussion in 'Patchbays' started by Shaun Johannes, Sep 23, 2010.

  1. Shaun Johannes

    Shaun Johannes Active Member

    Hey Guys:smile:

    Attached is a PDF of of my proposed patchbay layout.

    Please let me know if I'm going about it the right way and please especially comment on the 'un-balanced TS or balanced TRS' cables!!

    Basic Setup:

    Toft ATB24

    - sound source via XLR input into desk
    - direct outputs from desk to patchbays
    - signal after preamp, fx, etc. back into desk via 1/4" jack line input

    MOTU 24 i/o

    - Inputs via TRS from 'half-normaled' patchbay 'A'
    - Outputs via TRS to patchbays for signal processing

    Digi 003 & Focusrite OctoPre

    - Inputs via TRS from 'half-normaled' Patchbay 'B'
    - 8 inputs analog + 8 inputs digital/ADAT (from Focusrite)
    - Outputs via TRS (from both units) for signal processing

    Thanks so much for your help and invaluable advice:biggrin:

    File: (Dead Link Removed)
     

Share This Page