1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

PC motherboards for ProTools HD Accel

Discussion in 'Pro Tools' started by Trailerman, Sep 15, 2004.

  1. Trailerman

    Trailerman Guest

    We're about to buy an HD3 Accel setup to run on PC. I'm trying to get some information on which motherboards people are successfully using for this kind of rig.

    In particular, has anybody had any luck with a Supermicro X5DA8 or other motherboards using the Intel E7505 chipset. This chipset is used on the two Digidesign certified systems, but I've seen at least one person have problems with it on a custom-built system.

    If anybody has any input, advice, assistance, I'd be extremely grateful.

    Many thanks

  2. BladeSG

    BladeSG Guest

  3. Trailerman

    Trailerman Guest

    Thanks Blade

    Although the chipset I want to use is also in both the Digi recommended systems, it's not even mentioned in their compatibiity information - not quite sure what that's supposed to mean. Hence the request here.

    Thanks again


Share This Page