Hi there, I have posted a few times trying to get my mac to work and know i'm ready to toss it out the window!!! I have two computers and I'm looking for a temporary solution to get my studio up and running untill I can upgrade to a power book or dual g4 with my digi 001 or buy a digi 002. I have: PC p3 733 chip, 380 meg pc 100 ram(with two open slots),dvdr+,win 98 or xp mac 9600/300 pre g3, a non-mac ge axcelerated chip(and the original chip), 384 meg ram (w/ 6 or 8 siots open), 1 10 gig scisi(running os 9.1), scsi card runing 2 17 gig ide drives(one for protools, and the other for write only for protools), digi 001 (w/ both mac and pc disk for protools) ADAT 20 bit trs (only for light pipe in/outs) Because the mac has a non-mac chip in it now, I can not upgrade to os 9.2.2, but I have the original chip I can put back in. What do I do?!? Use mac as is and fight with it (it worked fine for 6 or so sessions, then I used a cracked plug-in and all hell broke lose). or Put the slower mac chip in so I can upgrade to os 9.2.2.? or Sell the mac and use the money for pc parts and a new mac? or If any one knows if mac made a G3 chip for the pre g3 computer (where do i get one what is it called and how much are they)? Other Questions. Of the three ways listed above how many tracks do you think I can run at one time? Of the three ways listed above can I still use my ADAT for more in/out(will the old mac chip or pc be able to handle the load)? If I use the pc does protools offer a download to use xp or do I stick with 98? By the way, the post is; Error 9073!! Can't get audio from drive fast enough. HELP!!