1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

pitch problems with conversions

Discussion in 'Converters / Interfaces' started by lobsterman, Dec 11, 2004.

  1. lobsterman

    lobsterman Guest

    I am recording a demo with my band. Weve been recording to a Roland VS-890 (when we need to multi track simultaneously) then we are sending two tracks at a time out the digital out into an M-Audio Audiophile USB. Then the tracks record to Adobe Audition. Some tracks are coming over fine. But some tracks pitch is being altered as much as up a whole step.

    Has anyone else had problems like these? Why does it happen? Where in the signal chain does it happen? What can i do?
     
  2. David French

    David French Well-Known Member

    Hmm... sounds like a difference of sample rates. 48 kHz to 44.1 kHz is about 1.5 half steps, so that's probably it. I assume you're using SPDIF. Make sure your clock source on on the M-Audio card is set to 'SPDIF', 'external', or whatever would indicate that it is using the VS-890 as the clock source. Also make sure that the sampling rates on the two devices are the same.
     

Share This Page