1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Pro Tools LE Help

Discussion in 'Pro Tools' started by Rip, Jan 14, 2005.

  1. Rip

    Rip Guest

    Sorry for the sorta double post (see Autotune Help), but I realized that some PT users might pass over that thread.

    I have a vocal track that I tweaked with Antares Autotune in graphical mode, and I would like to bus my results and record them to an aux track. Problem is, I am a newbie to PT and do not know how to do this. I looked at the manual but could not find how to do this. Could you give me a walkthru?

    (I already have an aux track setup...)

  2. Kev

    Kev Well-Known Member

    Nov 13, 2001
    but I don't think we want an aux for this job ?

    Original track with AutoTune
    route the output of this track to bus 1
    ... I assume it is mono

    new audio track and set input set to bus 1
    Put this new track into Record and and while in play mode you should see and hear the AutoTune track comming through this.

    Set a record area and then hit record.
  3. Johnjm22

    Johnjm22 Guest

    Since your a PT user, you may want to check out duc.digidesign.com

    Lot's of helpful info for PT users over there.
  4. Rip

    Rip Guest

    Thanks for the suggestions! I appreciate them both... :D

Share This Page