1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Pro Tools Monitoring

Discussion in 'Pro Tools' started by hbj, Jan 25, 2004.

  1. hbj

    hbj Guest

    Does anyone here know of a clean-sounding box that can essentially serve as a monitor section for ProTools? I.e., the L-R of Protools would feed this box through a volume pot (and possibly a mono summing bus) and then right to the monitors? I'm using a Mackie mixer now which has three individual gain stages, plus an unswitchable EQ. All that can't be helping the signal!

    I know Coleman audio makes the M3PH, but it's -SO- expensive. Anyone know anything good but cheaper?

    Thanks!
     
  2. Bill Park

    Bill Park Guest

    Mackie Big Knob, the aforementioned ColemanAudio, NHTPro, doesn't Samson have something like this? Bob Katz makes a digital one, SPL, I built one from a schematic that Bob passed along... I bet if you dropped into the Tech Talk section, you'd get some more ideas.

    Bill
     
  3. hbj

    hbj Guest

    Thanks! I'll check'em out.
     

Share This Page