1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

PROBLEMS WITH XLR AND MY PRE AMP

Discussion in 'Preamps / Channel Strips' started by reginald, Feb 18, 2005.

  1. reginald

    reginald Guest

    Ive got a preamplifier witha kind off mono mic input. I intend to use it with my mic which uses xlr out connecters. There are 3 output wires on my mic and 2 input wires on the preamp. How can i go about it and creat a balanced signal.
     
  2. Kev

    Kev Well-Known Member

    mmmm
    :roll:
    it is likely this pre-amp will not work with a phantom mic so I hope we are talking about a dynamic mic.
    Get a normal (hah normal) XLR female to 1/4 inch phono lead ... where the pin 3 is grounded at the phono

    I think this is what you are describing as mono input ???
    don't say mono or stereo as in truth it is a TS ( tip sleeve) or a TRS (tip,ring,sleeve) connector.

    hope that makes some sense
     

Share This Page