1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

PT Bounce To Disk problem....

Discussion in 'Recording' started by mark_van_j, Dec 12, 2005.

  1. mark_van_j

    mark_van_j Active Member

    Every now and then I use the bounce to disk function in Pro Tools LE (V. 6.8.1) and I get the following error message after it is done bouncing:

    Could not complete the Bounce to Disk... command because Assertion in "\code\azores_Ray_Release\AlturaPorts\NewFileLibs\FF\Audio\FF_AudioProperty.cpp", line 33


    This doesn't happen all the time, but when it does, it's annoying. Is anyone else getting this?
     
  2. Dave62

    Dave62 Guest

    I had this problem from time to time in v6.7 and digi's answer was to move the start or end of the selection 2B bnced, which didn't always work. Hasn't happened in v7 yet but I have only had it 2 weeks. Kind of frustating when clients are sitting their. I finally started busin it to two open tracks and then exporting a stereo file from that. Still a pain in the wazoo..
     

Share This Page