1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

question about 002 rack and pro-8 digital , cracks in sound

Discussion in 'Recording' started by DenLegend, May 31, 2007.

  1. DenLegend

    DenLegend Guest

    I have my ultragain pro-8 out into my 002 rack to record drums . its cracking though randomly and really not recordable till these cracks are gone..

    Advice how can i fix this
     
  2. Ballz

    Ballz Guest

    your sample rate is set wrong. If you are recording at 48kHz in Pro Tool, make sure the switch is set the same on the back of the ADA8000.

    If the pops and clicks persist after you have made sure the sample rates are set the same, go into your "Setups" menu, select "Hardware Setup" and set the clock to "Optical".
     
  3. DenLegend

    DenLegend Guest

    How do i change my 41kHz on the 002 rack to 48??
     
  4. Boswell

    Boswell Moderator Distinguished Member

    I would run the recording at 44.1 KHz if you are going to be burning to CD at the end of it all, so the ADA8000 switch should be set to 44.1KHz.

    However, I think that your pops and clicks are unlikely to be due to a sampling rate issue, rather a matter of checking that the 002 clock source is set to ADAT in PT.
     
  5. BobRogers

    BobRogers Well-Known Member

    That's almost certainly the answer.
     
  6. DenLegend

    DenLegend Guest

    worked, thanks
     

Share This Page