1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Reply 2 to David French re Loading Kontact samples

Discussion in 'Recording' started by speakeasy, Nov 17, 2006.

  1. speakeasy

    speakeasy Guest

    Hi David.
    Well I followed your instructions , but I may be doing something wrong.
    I noticed that there is a small red signal that co responds with the relative key strike. I placed my first file there and edited the left and right points as you instructed. But when I dragged and dropped my next chromatic note file onto the next key position and did the same, strange things happened. 1: the second note wouldn't play. 2: if it did it was way out of pitch.
    I have Nemesys Megapiano multi samples which load fine.
    I have always wanted to be able to load other multi sample sets, particularly Rhodes. But I just can't seem to get there. Any suggests ?

    cheers, speakeasy
     
  2. David French

    David French Well-Known Member

    Perhaps the second sample is not the same pitch as the key you mapped it to? You do have each note sampled, right?

    As for volume, make sure that your blue region stretches from bottom to top. If it does, then any velocity on that pitch will trigger it.
     
  3. speakeasy

    speakeasy Guest

    Reply 3 to david French / Kontact samples

    Yes I thought the sampled note was the correct pitch but I'll try again.
    The main problem is that when I load and stretch the 2 nd sample note it doesn't play. The sample notes I have are all ones I freely downloaded. Most of them do not offer every chromatic note, and I'm having a bit of trouble when I choose a note that's an octave too high or low if you nkow what I mean ? ...I'll keep trying. Thanks David
     
  4. speakeasy

    speakeasy Guest

    David. Thanks sincerely !! I am successfully loading all my samples !

    cheers, Speakeasy
     
  5. David French

    David French Well-Known Member

    No problem.
     

Share This Page