Reverb/delay and EQ placement help

Discussion in 'Tracking / Mixing / Editing' started by mcmilliron, Apr 4, 2005.

  1. mcmilliron

    mcmilliron Guest

    first question: delay and reverb are placed after the Preamp in your signal chain right?

    mic/preamp/delay/reverb/soundcard is this right?

    second question: where would a EQ be placed in this signal chain?

    thanks in advance
     
  2. shezan

    shezan Guest

    1....if you are recording through this chain then why don't you just go for like mic/preamp/recording device.....
    later on you can add reverbs and delays of as many kind or choice u want....once the voice recorded with the effects..will remain in the same manner you cannot mute the fx...record the plain vocal...

    2.... since going directly to the card..the interface similarly as you can add reverbs and delays later on...almost every software has its own track eqs....

    good luck...
     
  3. mcmilliron

    mcmilliron Guest

    thanks for the advice :D

    I actually want to record my rack effects direct to disk. I realize that most people would disagree with this but I'm a musician not an engineer and I'm only recording for writing purposes. I don't want to spend the time it takes to go through plugins and setting up aux sends.

    thanks,
     
  4. iq

    iq Guest

    IMHO, it's best to place the EQ after the preamp.

    mic/preamp/EQ/delay/reverb/soundcard
    :cool:

    Best luck!
     
  5. mcmilliron

    mcmilliron Guest

    Thanks for the reply IQ :D
     

Share This Page