1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Rode NT1 problem

Discussion in 'Microphones' started by dochara, Sep 13, 2013.

  1. dochara

    dochara Active Member

    Jul 23, 2012
    Hello, I've been using a Behringer B-1 for recording vocals for the past few years but some time ago, I invested in a Rode NT-1 which had been recommended by many. I'm sure it's an excellent microphone but I am having two regular problems with it.

    First, there are 'pops' everywhere - beginning words especially but also in silent parts between lines.

    Secondly, the recording levels have to be set much higher than the Behringer to get to a similar level.

    I use Sonar Producer 8.5 and a simple Cakewalk UA-25EX interface (phantom power). I have tried different cables with no improvement. Could it be that my PC is not powerful enough? It's an old Dell but it's fine with everything else including instruments.

    Any advice welcome, thanks. thumb
  2. Kuroneku

    Kuroneku Active Member

    Mar 19, 2013
    What is the music genre you are recording?
    I've been using the same mic, and I just figured that this is not the best microphone for Rock vocals. The settings matter very much both on your audio interface and Computer, because it's such a sensitive mic. It really picks up everything

Share This Page