1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

setup advice

Discussion in 'Recording' started by robb007, Nov 11, 2003.

  1. robb007

    robb007 Guest

    Hi people!
    I have run into a bit of a snag and would appreciate an opinion or 2.The dellima goes like this I am running a Tascam dm24 and pc set up running frontier design Dakota montana 3 rme adi converters {24 channels in and out}what is the best way to get the most out of this set up?that is adat light pipe routing.

  2. mjones4th

    mjones4th Active Member

    Aug 15, 2003
    The key in any DAW setup is to avoid conversion of signals. analog to digital, digital to analog, sample rate conversion, and bit depth conversion are the key factors that degrade digital audio signals.

    convert once and record to disk. whether its your tango, ADI or DM24.

    I'd recommend you use the RME or Tango converters. Is there a reason you have so many converters? Do you need the mixer?

    It really depends on what you're recording tho.

  3. robb007

    robb007 Guest

    I really like the summing of a console.I think the sound has more clarity and punch.Anyway I would like to go into the converters analog for use with different pre amps Avalon Presonus ect***Into 3 converter pieces {bank[A] bank{ b }bank[ c }and out of the converters to the soundcard and out to the console via 3 dm24 light pipe cards. The problem I am having is say I plug a Bass into channel one of bank {A]With this setup i can't hear monitor back through the console it seems to me the clocking is confused any other takers for solving the problem?

Share This Page