1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Shielding for NS10's

Discussion in 'Monitoring / Headphones' started by vividsonics, Jun 2, 2005.

  1. vividsonics

    vividsonics Guest

    I'm considering moving some things around in my control room and was thinking of putting my CRT monitors between my NS10's. How could I go about shielding the drivers in the NS10's so there's no issues between the CRT's and the NS10's? Thanks.
     
  2. frob

    frob Well-Known Member

    get a couple of lcds insted of thouse old crts.
     
  3. ErikFlipside

    ErikFlipside Guest

    I'd like to know this as well. My NS-10Ms have to be placed very close to dual 17" CRTs. Replacing the CRTs with LCDs is -not- feasible.
     
  4. ErikFlipside

    ErikFlipside Guest

    MEGA BUMP!

    Any ideas on shielding NS-10s?
     
  5. iznogood

    iznogood Member

    shielding the ns-10's will affect the magnetic fields of the drivers.... thereby changing sound!!

    don't do it!!

    get better monitors.... (audio or visual)
     
  6. Shield the CRT monitors.
     
  7. ErikFlipside

    ErikFlipside Guest

  8. Its done the same way as shielding speaker cabs, except this time you build a box for your CRT monitor. You just have to make sure you have plenty of ventilation, as those babies get HOT!
     
  9. iznogood

    iznogood Member

    if you can do that cheaper than a couple of new flatscreens i'm amazed...
     
  10. Kurt Foster

    Kurt Foster Distinguished Member

    My thoughts as well ... You need to use MU Metal to shield eletronic components. Considering the cost of the Mu Metal, just switching over the flat panel monitors would most likely be the cheaper way to go. Plus you will get the added benifit of less heat and lass space constraints. I love my flat panel monitor. IMO it's a much better investmrent than something like a control surface.
     
  11. ErikFlipside

    ErikFlipside Guest

    I was hoping there would be a simple, cheap way to do it until around xmas time when a friend might be selling his dual 19" LCDs. Oh well.
     
  12. midigod

    midigod Guest

    There is. Get some magnetic tape from Radio Shack, and experiment with putting it around the CRT at various places and angles. You should be able to find a position suitable enough to counteract the magnetism from the NS-10s. You may have to turn the tape around, depending on the polarity of the tape versus the NS-10. You can also use those little square magnets from a hardware store if the speaker is REALLY close.

    Don't worry about messing up the CRT in this scenario, as the fields are cancelling each other out.

    Also, you'd have to induce one mother of a magnetic field to affect the way a speaker sounds.
     

Share This Page