1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Signal flow

Discussion in 'Recording' started by and-mart, Jun 16, 2005.

  1. and-mart

    and-mart Guest

    I route the signal the following way:

    1. Mic
    2. snake
    3. Behringer UB2442FX Mixer
    4. Digi002Rack
    5. Computer

    If you get a decent preamp, will it be better to ignore the mixer (I know behringer stuff is not good at all), and just go directly to the digi002 through the preamp (via ADAT for example) and use the mixer for monitoring only?

    1. Mic
    2. Snake
    3. Preamp (eg. digimax, octopre?)
    4. Digi002r
    5. Computer

    and for monitoring:


    Or maybe keep a mixer in the flow (a good mixer) and the preamp as well?

    Any comments/advice?

    Thank you
  2. iznogood

    iznogood Guest

    skip the mixer and buy a pre that you connect directly to the digi002

    and connect the speakers to the monitor out of digi

    unless of course you have loads of other gear hooked up to the mixer

Share This Page