1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Struggling to find correct ipad holder for mic stand

Discussion in 'Studio Lounge' started by joennick, Jun 23, 2014.

  1. joennick

    joennick Active Member

    Hi All

    I'm trying to get away from the old fashioned lyric sheet stand.....yes I know I shouldn't need one!

    Anyway I use a straight mic (no boom) and all I can find are ipad mounts that are held to the side or between me and the mic stand which is too uncomfortable. I can't seem to find one that sits out front in a similar position to where a lyric stand would be. I'd prefer it if the mic stand was in between me and the ipad if that makes sense.

    Any suggestions?

  2. dvdhawk

    dvdhawk Well-Known Member

    It seems to me that something like this from the OnStage U-Mount Line could be positioned on any side of the mic stand - and still rotate the iPad to face you. Two points of contact that rotate 360˚and a ball joint too. Have a look.

    You could always go to a drum shop. A well-stocked drum shop will usually have every kind of clamp, boom, and offset arm under the sun. Clamp one end to your mic stand, clamp the other to the iPad mount.

    Best of luck.
  3. paulears

    paulears Well-Known Member

    I use the Behringher P16 monitor mixer, and had the same issue. It now has it's own stand, which is much simpler, and less expensive than the clever arms which cost more than a full mic stand!
  4. joennick

    joennick Active Member

    Thanks for the replies.

    The u mount appears to attach to the top of of a Mic stand (unless I'm looking at it wrong). I want something waist height to attach to my Mic stand that already has my microphone attached.
  5. DonnyThompson

    DonnyThompson Distinguished Member

    That's a good idea Dave, Heck, if they can make mic stand mountable ashtrays and beer can holders, ya just know they have to have something for an ipad that makes sense.
  6. joennick

    joennick Active Member

    Actually I see it now! Yes that might work. I'll check it out.


Share This Page